Category: General Electrical

  • Car charger installation in Holme

    A brand new electric vehicle charging point was installed at this lovely property in Holme village Preparation Before installation began, a sizeable 25m 3-core 10mm2 armoured cable was installed, running from the car charger at the end of the garden down to the house. The cable was run through trenches and up the corner of…

  • Fan of Fans

    First contact During the first visit to this property in Burton-in-Kendal, two smoke detection devices and one extractor fan were replaced. The smoke detectors were accessible from a small hop-up. These devices were wired in using three-core cable. One for live, one for neutral, and the other is used for communication between the two units.…

  • Commercial Lighting Disconnection for KFC

    The Problem At this KFC, some exterior commercial lighting needed disconnecting, and so the first step was the identification of the correct cables. There were many challenges, including lots of cables and the distracting smells of fried chicken. The Solution Despite the challenges, the correct circuits for the lights were soon identified. Access was provided…

  • (PIV) Positive Input Ventilation Installation

    Process This beautiful and effective Positive Input Ventilator (PIV) was installed in the second floor of this house near Grange. Using the provided template, a hole was cut in the ceiling for the PIV and heating element to rest, while the fan body was installed suspended below a rafter. The electrical supply was taken from…

  • Outdoor lighting – lamp posts

    These stunning, vintage; warm lamps have been fitted including all wiring! Including wireless switching… Installed in a large property grounds, these gorgeous, warm lights welcome people in. They light up the whole garden, while still not glaring peoples eyes. Sensors can be added to these lights, to immediately light up when motion is detected. Behind…